Sapicalculator

Home›Engineering calculators›Roof Pitch Calculator

Construction / roof geometry

Roof Pitch Calculator

Convert roof rise and run into pitch, angle and percentage slope.

Formula basedLocal calculationSI units
⌂
INPUTRESULT
FIELD NOTE / ROOF

Enter your measurements

LIVE

Use the units shown beside each field. Change any value and recalculate.

Calculated result

Ready
—Pitch ratio
—Roof angle
—Slope percentage
Roof angle—
Slope percentage—
Enter values above to create a result.

How the variables relate

The diagram is a visual reminder of the dimensions used in the calculation.

ABC

How to use this tool

  1. 1Enter the rise in the unit shown.
  2. 2Enter the run in the unit shown.
  3. 3Review the result and check it against your project specification.

Pitch = rise ÷ run; angle = arctan(rise ÷ run)

The calculator keeps the displayed units visible so the result can be checked without guessing what each number means.

Values are rounded for display. Keep full precision when transferring a result to a drawing or schedule.

Before you build or order

  • Use the horizontal run, not the rafter length, for pitch calculations.
  • Pitch ratios are commonly written as rise:12 in imperial drawings.
  • Confirm local snow, wind and drainage requirements separately.

Common questions

What does this calculator estimate?

Convert roof rise and run into pitch, angle and percentage slope. Results are intended for planning and checking, then should be confirmed against project drawings, supplier data or local code.

Are the calculations performed locally?

Yes. The page calculates in your browser, updates immediately, and does not require an external data service.

What should I verify before ordering?

Verify dimensions, units, tolerances, waste allowance and the specification supplied by your engineer or material manufacturer.

Common questions

What does this calculator estimate?

Convert roof rise and run into pitch, angle and percentage slope. Results are intended for planning and checking, then should be confirmed against project drawings, supplier data or local code.

Are the calculations performed locally?

Yes. The page calculates in your browser, updates immediately, and does not require an external data service.

What should I verify before ordering?

Verify dimensions, units, tolerances, waste allowance and the specification supplied by your engineer or material manufacturer.

Roof Pitch Calculator for real-world planning

Convert roof rise and run into pitch, angle and percentage slope. This page explains the inputs, the formula and the assumptions behind the result, so you can use it as a quick design check rather than a black-box number generator. It works on desktop and mobile, performs calculations locally, and keeps the measurement units next to every field.